Simulink Scope Layout and Signal Selection

Question

Hi, I can't define which of my input signals fall into which part of the layout in the Simulink Scope.      I have 3 signals. I setup the scope layout to 1 column, 2 rows (2 views, top and bottom). I can't then find a way to put signals 1 & 2 on the top scope and signal 3 on the bottom..                          Edit: I see that under [settings > Main > Number of Input ports] there's a button that says 'Layout'. This button is not greyed out but has no action (literally nothing happens)   I'm using R2015b (Simulink 8.6)

Kshitij Singh · Accepted Answer

Here is the default behavior of the layout button explained in the documentation. To quote it, "If the number of displays are less than the number of ports, signals from additional ports appear on the last display."
In the newer scopes there does not seem to be way (in my understanding) to assign signals to particular axes. The way you can get around this is to use a mux block and feed in signals appropriately to make sure you get the layout and signals assigned reliably. Example snapshot of implementation and display below:

Simulink Scope Layout and Signal Selection

Need a Custom Version or Complete Simulation for This Problem?

Why am I receiving error messages about singularities in my Simulink model?

Simulink turn off data logging

Simulink PID Controller Tuning

Error evaluating parameter 'Value' in simulink

select bus elements programmatically

How do I save my Simulink model as a TIFF or JPEG image?

IEEE 13-BUS Hybrid AC & DC Power Distribution System using MATLAB Simulink

Adaptive Path Planning and Collision Avoidance for Autonomous Vehicles on Unstructured Indian Roads

Lithium-Ion Battery Electro-Thermal Modeling and Cooling Analysis in MATLAB

Get a Free Consultation or a Sample Assignment Review!