Is it possible to exclude blocks for coverage analysis from Simulink Test Manager in R2017b?

Question

I am wondering whether there is a way to exclude blocks for coverage analysis from the Test Manager.   Even if I right-click on a block in the model and exclude it from coverage analysis, when I run a test in the Test Manager and generate the coverage report, the block has not been actually excluded.

Kshitij Singh · Accepted Answer

It is possible to do so by first saving your filter to a file, and then setting the filter (CovFilter) in the model.
Please refer to the following steps:
 
1. Open Simulink model:
 
>> slvnvdemo_covfilt
 
2. Right click on 'Normal config (feedthrough)' > Coverage > Exclude subsystem with all descendants
 
3. For Rationale, type 'myRationale', then Apply
 
4. From the Filter Viewer, click on Save Filter and save as 'myFilter.cvf'
 
5. In Configuration Parameters, navigate to Coverage > Advanced Parameters > Coverage filter filename, and specify name of the filer ('myFilter' in this case)
 
This can also be done programmatically as follows:
>> set_param(gcs,'CovFilter','myFilter')
 
6. From the model, click on Analysis > Test manager
 
7. New > Test File, and save as 'myTest.mldatx'
 
8. For System under test, select 'use current model'
 
9. In the Test File 'myTest', navigate to Coverage settings and select 'Record coverage for system under test'
 
10. Run test
 
Now, go to the Results and Artifacts section, navigate to Aggregated Coverage Results to generate report, and verify that SubSystem block "Normal config (feedthrough)" has been excluded from coverage analysis.

Is it possible to exclude blocks for coverage analysis from Simulink Test Manager in R2017b?

Need a Custom Version or Complete Simulation for This Problem?

Resolving missing coverage using simulink design verifier and not by using simulink test

Why does model coverage in Simulink Verification and Validation return uncovered conditions for temporal logic events in Stateflow charts?

Design verifier :run all and produce coverage for a sldvmakeharness created model

How to I use get param to get a value from an output of a bus?

How do I uninstall and reinstall MathWorks Service Host?

Why am I receiving error messages about singularities in my Simulink model?

Modeling and Simulation of an Induction Motor Using Sliding Mode Control in MATLAB

Solar Inverter with BMS in MATLAB Simulink Complete Simulation Project

Simulation and Kinematic Analysis of a 5-DOF RRRRRP Robotic Manipulator Using MATLAB

Get a Free Consultation or a Sample Assignment Review!